Friday, August 30, 2013

Anesthesia 6 Induction Steps drugs equipment



Intravenous Induction

Objectives

     To induce loss of awareness rapidly at the start of anesthesia.

     Induction is achieved with intravenous agents (thiopentone 3-5 mg/kg, methohexitone 1-1.5 mg/kg, etomidate 0.3 mg/kg, propofol 1.5-2.5 mg/kg or ketamine 2 mg/kg).

Position

Supine.

Premedications

Any combination of anxiolite and antisialgogue.

Procedure

     Intravenous cannula inserted into a peripheral vein, preferably on the dorsum of the hand and infusion fluid attached

     Drugs prepared in syringes and labelled (IV induction agent, muscle relaxant, atropine)

     Patient connected to the monitor for ECG, non-invasive blood pressure (NIBP), and oxygen saturation

     100% oxygen by mask before the drugs are injected

     Small test dose of intravenous induction agent given and effects observed for any anaphylactic reaction

     Slow injection of the drug into the vein till the eye lash reflex is obtained

     Rapid sequence induction technique used in emergency situation where the stomach is full or chances of regurgitation are a potential problem

     Anesthesia maintained with inhalational agent

     Tracheal intubation done using muscle relaxant.

Instruments

     Intubation tray

     Anesthesia machine (Check list I, )

     Breathing circuits, face mask, inhalation set (Check list I, )

     IV cannula, infusion, fluid, spirit and Iodine swab, adhesive plaster

     Drug tray and labels

     Normal saline bottle for dilution of drugs

     Induction agents - Thropentone, Propofol, ketamine

     Arm boards

     Patient monitors for ECG, Spo2, NIBP, ETCO2 

     Anesthesia machine monitors (Oxygen analyser, gas monitor)

     Emergency drug tray (Check list II, see).
Any questions be sent to drmmkapur@gmail.com
All older posts are stored in archives for access and review.
Visitors that follow may post contributions to the site.
To create consumer/provider engageent visit www.sugseminar.blogspot.com

Friday, August 23, 2013

Anesthesia 5 General


GENERAL ANESTHESIA

General anesthesia is a reversible, drug-induced state of non-responsiveness to outside stimuli.

      With the use of agents such as the muscle relaxants, modern general anesthesia aims at a balance between ‘relaxation’, ‘analgesia’ and lack of awareness.

      General anesthesia is achieved by using intravenous or inhalational agents (gases or vapours)

     Patient receives a premedication one hour before the anesthetic procedure

     The next step to anesthesia is induction which can be achieved by administration of intravenous drugs or inhalation agents

     On induction, muscle relaxation is necessary to facilitate tracheal intubation. Relaxation during maintenance of anesthesia is also required.

Intravenous Inducting Agents

Intravenous anesthetic agents are used commonly in anesthesia as induction agent. Induction is more rapid and smoother than that associated with inhalational agents. Sometime for maintenance also, these agents can be used.

 

             The intravenous agents (IVA) can be classified as:

      A.  Rapidly acting agents:

             1.   Thiopentone (Barbiturate).

             2.   Etomidate (Imidazole compound).

             3.   Propofol (Phenol group).

             4.   Propanidid (Eugenol derivative).

      B.  Slower acting:

             1.   Ketamine (Phenocyclidine derivative).

             2.   Diazepam and other benezodiazepine derivative.

             3.   Morphine, fentanyl, alfentanyl, sufentanil (Narcotics).

             4.   Haloperidol, droperidol with opioids.
All questions be sent to drmmkapur@gmail.com
All older posts are stored in archives for access and review.
Visitors that follow may post contributions to the site.
To create consumer/provider engagement visit www.surgseminar.blogspot.com

Friday, August 16, 2013

ANESTHESIA 4 Premedication


GENERAL PRINCIPLES

Premedication and Anesthesia

Premedication is the prescribing of drugs to be administered preoperatively. These are usually agents prescribed by the anesthetist, at the preoperative visit.

     To reduce anxiety

     To relieve pain

     To dry saliva.

Morphine Sulphate

     Morphine is a narcotic analgesic

     It depresses awareness, anxiety, pain.

It is used :

     As a premedicant.

Diazepam

     This is a minor tranquilizer

     It relieves tension and anxiety

     It is used mainly as a premedicant.

Antisialgogue

     These produce drying of the salivary and respiratory secre-tion

     The drugs include atropine sulphate, glycopyrrolate and hyoscine

     One of them is used as a premedicant drug along with analgesics.
Any questions be sent to drmmkapur@gmail.com
All older posts are stored in archives for access and review.
Visitors that follow may post contributions to the site.
To create consumer/provider engagement visit www.surgseminar.blogspot.com

Friday, August 9, 2013

ANETHESIA Equipment 3 anesthesia room



ANESTHESIA ROOM

The anesthesia room is used for preoperative preparation of the patient and;

     Induction of anesthesia.

     Giving regional techniques.

     Short term observation of patients after anesthesia.

It is situated next and on the way to the OT

The anesthesia room should have:

     A tiltable and portable table

     An Anesthesia machine

     Intubation equipments

     A drug trolley

     A blood pressure instrument

     Oxygen saturation monitoring equipments

     Suction apparatus.
Any questions be sent to drmmkapur@gmail.com
All older posts are stored in archives for access and review.
Visitors that follow may post contributions to the site.
To create consumer/provider engagement visit www.surgseminar.blogspot.com

Friday, August 2, 2013

ANESTHESIA Equipment 2 Duties Checklist



THE DUTIES OF THE ANESTHESIA
NURSE AND ORA

The anesthesia nurse and operating room assistant (ORA) must familiarise himself/herself with the basic principles of all the equipments and drugs used in a particular theater in which she/he works.

     The maintenance of anesthesia equipment is the task of the maintenance unit. It is the anesthetist’s direct responsibility to finally check that the apparatus is working correctly before use.

     The anesthetist may give some tasks to the ORA depending on the ORA’s ability and knowledge.

     The anesthesia nurse or ORA with an understanding of mechanical equipment may obtain further information from the technical booklets supplied with a particular anesthesia machine or equipment.

     Information regarding working of the apparatus, functions, handling, safety precautions, ‘dos’ and ‘don’ts’ are important for the safety of both the patients and the equipment. These rules must be observed.

     Detailed information about New machines and equipments should be obtained from the technical booklets supplied with a particular machine before installation and use

     It is the duty of the ORA with this information to keep the equipments in functioning order, checking its functions and preparing the machine for use each day (see Fig. AIII.1)

     He also makes available the appropriate accessories and drugs required for each procedure

     The understanding of the working of the apparatus and steps of the procedure will help in selecting the right equipment and preplanning for the procedure.
Any questions be sent to drmmkapur@gmail.com
All older posts are stored in archives for accrss and review.
Visitors that follow may post contributions to the site.
To create consumer/provider engagement visit www.surgseminar.blogspot.com